Mushroom farm humidification
In mushroom production humidity is not a comfort question but a yield question. Of everything we install, mushroom humidification has the narrowest tolerance.
- System
- High pressure misting
- Control
- Sensor-driven control panel
- Area
- Nationwide, based in Ankara

Why humidity is critical
The moment ambient humidity falls, a mushroom starts giving up water from its surface. The cap dries, cracks and discolours, and the crop drops a grade. Because the ventilation system supplies fresh air continuously to clear carbon dioxide, the air in a growing room is naturally working in a drying direction.
That is precisely the job of a mushroom humidification system: to give back what the ventilation takes away. And it has to do so without wetting the crop or saturating the compost. That balance depends entirely on the system being built correctly.
The system we install
In growing rooms we install high pressure misting. High pressure nozzles produce a very fine fog that disperses in the air and raises humidity, leaving no droplets on any surface.
The system is connected to a humidity sensor through a control panel. When the reading drops below the target band the system starts; when the band is reached it stops. That both reduces water consumption and keeps humidity in the same range continuously. Where rooms are at different stages, each room is planned as its own zone.
How it differs from a greenhouse
Between greenhouse humidification and mushroom humidification the equipment is the same; the tolerance is not. In a greenhouse humidity can wander across a wide band. In a growing room that band is far narrower, and leaving it affects yield directly.
The practical consequence: in a mushroom facility the system runs in short bursts tied to a sensor, not for long stretches. A growing room system built around a timer will almost always deliver either too much humidity or too little.
Quotation and installation
The cost of a mushroom humidification system is determined by the number of rooms, their dimensions and the level of automation. Nozzle prices vary with the nozzle, filtration and pump selected, which is why we take the dimensions and prepare a quotation for you rather than giving an estimate over the phone.
We are based in Ankara and install across Türkiye; surveys in and around Ankara are free of charge. Send the width and length of your rooms through the contact page, or call 0507 492 02 04.
Frequently asked questions
Which system is installed for mushroom humidification?
Will misting wet the mushrooms or mark them?
Can it be retrofitted to my existing growing rooms?
What does a mushroom humidification system cost?
Related reading
Let's find the right system for your site
Just send us the width, length and height of the area in metres (e.g. 10 m × 20 m, 3 m high). Site survey and system design are free of charge.